Ground Illumination Light Removal/Installation

GROUND ILLUMINATION LIGHT REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the outer mirror glass. (See Outer Mirror Glass Removal.) Outer Mirror Glass Installation

3. Insert a small tape-wrapped flathead screwdriver into the service hole indicated in the figure.






4. While pressing tab A in the direction of the arrow (1), pull the ground illumination light in the direction of the arrow (2).






5. Remove the ground illumination light by pulling it in the direction of the arrow (3).

6. Pull the connectors in the direction of the arrow shown in the figure and disconnect them.






7. Install in the reverse order of removal.