Synchronizer Ring Inspection

Synchronizer Ring Inspection
1. Inspect the synchronizer ring teeth for damage, wear, and cracks.
^ If there is any malfunction, replace parts if necessary.
2. Inspect the tapered surface for wear and cracks.
^ If there is any malfunction, replace parts if necessary.





3. Measure the clearance between the synchronizer ring and the side of gear circumferentially using a feeler gauge.
^ If it is less than the minimum specification, replace the synchronizer ring.

1st and 2nd synchronizer ring clearance
Standard: 1.50 mm (0.059 in)
Minimum: 0.80 mm (0.031 in)