Antenna Feeder No.3 Inspection

ANTENNA FEEDER NO.3 INSPECTION

1. Disconnect the negative battery cable.

2. Remove the rain sensor cover. (with auto light / wiper system) Service and Repair

3. Disconnect the rain sensor connector. (with auto light / wiper system) Service and Repair

4. Disconnect the auto-dimming mirror connector. (with auto-dimming mirror) Auto-Dimming Mirror Removal Auto-Dimming Mirror Installation

5. Remove the following parts:
a. Sunroof seaming welt (with sunroof system)

b. A-pillar trim A-Pillar Trim Removal/Installation

c. Upper anchor of the front seat belt Front Seat Belt Removal/Installation

d. Front scuff plate Front Scuff Plate Removal/Installation

e. Rear scuff plate Rear Scuff Plate Removal/Installation

f. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

g. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

h. Rear seat cushion Rear Seat Cushion Removal/Installation

i. Rear side seat back Rear Side Seat Back Removal/Installation

j. C-pillar trim C-Pillar Trim Removal/Installation

k. Map light Map Light Removal/Installation

l. Sunvisor Service and Repair

m. Assist handle Service and Repair

n. Headliner Service and Repair

6. Disconnect the antenna feeder No.2.






7. Verify that the continuity between antenna feeder No.3 terminals is as indicated in the table.






- If not as indicated in the table, replace antenna feeder No.3.