Rearview Mirror Removal

REARVIEW MIRROR REMOVAL

Vehicles With Auto Light/Wiper System

1. Remove the rain sensor. Service and Repair

2. Make a tool as shown in the figure using wire.






CAUTION:
- Using the tool with bare hands can cause injury. Always wear gloves when using the tool.

- To prevent damage to the lens, do not use a flathead screwdriver.

3. Push the wire in the direction of the arrow shown in the figure.






4. Insert a tool into the position shown in the figure and release the tab in the direction of the arrow.






CAUTION:
- Perform the procedure while being careful not to damage the lens.

5. Pull the rearview mirror in the direction of the arrow shown in the figure and remove it.






CAUTION:
- When removing the rearview mirror, it may hit the headliner and cause a damage. Hold the rearview mirror with hands and be careful not to contact it with the headliner.

Vehicles Without Auto Light/Wiper System

1. Push the wire in the direction of the arrow shown in the figure.






2. Insert a flathead screwdriver between the rearview mirror and base.

3. Insert a tape-wrapped flathead screwdriver to the position shown in the figure and press the center part of the spring.






4. Pull out the rearview mirror toward the vehicle rear.