Engine Control Module: Service and Repair

PCM REMOVAL/INSTALLATION [MZI-3.7]

NOTE:
- For replace the PCM, Setup the M-MDS and perform the PCM configuration. Programming and Relearning

1. Disconnect the negative battery cable.

2. Remove the battery and battery tray. (See Removal and Replacement)

3. Remove all connectors and clips which may interfere with servicing.

4. Loosen the PCM bracket nuts.






5. Remove the PCM from the bracket.






6. When replacing the PCM on the vehicles, perform the following.

- PCM parameter reset. Keyless Entry System Advanced Keyless Entry and Push Button Start System

7. Remove the PCM bracket.






8. Install in the reverse order of removal.