Oil Seal (Manual Shaft) Replacement [AW6A-EL]

OIL SEAL (MANUAL SHAFT) REPLACEMENT [AW6A-EL]

CAUTION:
- Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign material on the connector when disconnecting.

1. Disconnect the negative battery cable.

2. Remove the air cleaner component. Service and Repair

3. Remove the TCM. TCM Removal/Installation [AW6A-EL]

CAUTION:
- Do not damage the transaxle case.
- Do not damage the manual shaft.

4. Remove and discard the oil seal using a tape-wrapped flathead screwdriver.






CAUTION:
- Do not damage the oil seal.

5. Using the SST and a hammer, tap a new oil seal so that the specified oil seal position is obtained.






Substitution SST
- 49 F026 102
Outer diameter: 27 mm {1.06 in} or more
Inner diameter: 15-18 mm {0.60-0.70 in}
Plate thickness: 2 mm {0.08 in} or more

6. Install the TCM. TCM Removal/Installation [AW6A-EL]

7. Install the air cleaner component. Service and Repair

8. Connect the negative battery cable.