Power Window Subswitch Inspection

POWER WINDOW SUBSWITCH INSPECTION

Front Side

1. Disconnect the negative battery cable.

2. Remove the inner garnish. (front passenger's side) Inner Garnish Removal/Installation

3. Remove the front door trim. (front passenger's side) Front Door Trim Removal/Installation

4. Remove the rear door trim. (rear side) Front Door Trim Removal/Installation

5. Connect the negative battery cable.

6. Measure the voltage at each terminal (other than terminals H and I).

- If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item(s)" and related wiring harnesses.

7. Inspect the power window subswitch connector for continuity at terminals H and I.

8. If the system does not work properly even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window subswitch.










Rear Side

1. Verify continuity as indicated in the table.






- If not as indicated in the table, replace the power window subswitch.