Antenna Feeder No.2 Removal/Installation
ANTENNA FEEDER NO.2 REMOVAL/INSTALLATION
Except Power Retractable Hardtop
1. Remove the battery cover.
2. Disconnect the negative battery cable. Removal and Replacement
3. Remove the following parts:
a. Seat (RH) Seat Removal/Installation
b. Console Console Removal/Installation
c. Quarter trim Quarter Trim Removal/Installation
d. Scuff plate Scuff Plate Removal/Installation
e. Front side trim (RH) Front Side Trim Removal/Installation
f. Tire house trim Tire House Trim Removal/Installation
g. Aeroboard Service and Repair
h. Front seat bar garnish Seat Back Bar Garnish Removal/Installation
i. Back trim Back Trim Removal/Installation
j. Seat belt set plate Service and Repair
k. Seat back crossmember assembly Service and Repair
l. Rear side trim Rear Side Trim Removal/Installation
m. Rear package trim Service and Repair
n. Side shelf (RH) Side Shelf Removal/Installation
o. Trunk end trim Trunk End Trim Removal/Installation
p. Partition board
q. Trunk side trim (RH)
4. Disconnect the antenna feeder No.1.
5. Remove the clip A.
6. Partially peel back the floor covering.
7. Detach clips B.
8. Detach clips C.
9. Disconnect the wiring harness from the clip D.
10. Disconnect the connector.
11. Detach clips D and E.
12. Remove the antenna feeder No.2.
13. Install in the reverse order of removal.
Power Retractable Hardtop
1. Remove the battery cover.
2. Disconnect the negative battery cable. Removal and Replacement
3. Remove the following parts:
a. Seat (RH) Seat Removal/Installation
b. Console Console Removal/Installation
c. Quarter trim Quarter Trim Removal/Installation
d. Scuff plate Scuff Plate Removal/Installation
e. Front side trim (RH) Front Side Trim Removal/Installation
f. Tire house trim Tire House Trim Removal/Installation
g. Aeroboard Service and Repair
h. Front seat back bar garnish Seat Back Bar Garnish Removal/Installation
i. Back trim Back Trim Removal/Installation
j. Rear side trim Rear Side Trim Removal/Installation
k. Side shelf (RH) Side Shelf Removal/Installation
l. Trunk end trim Trunk End Trim Removal/Installation
m. Partition board
n. Trunk side trim (RH)
4. Disconnect the antenna feeder No.1.
5. Remove the clip A.
6. Partially peel back the floor covering.
7. Detach clips B.
8. Detach clips C.
9. Disconnect the wiring harness from the clip D.
10. Disconnect the connector.
11. Detach clips D and E.
12. Remove the antenna feeder No.2.
13. Install in the reverse order of removal.