Front Seat Back Component [Vehicles Without Power Seat System] Removal/Installation

FRONT SEAT BACK COMPONENT [VEHICLES WITHOUT POWER SEAT SYSTEM] REMOVAL/INSTALLATION

WARNING:
- Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings before handling a front seat (with built-in side air bag). Air Bag System Service Warnings

CAUTION:
- After removing a front seat, do not operate the slider lever. If the slider lever is operated, the left and right slide positions will deviate, and the slide adjuster may be damaged after the front seat is installed.
- Verify that there are no malfunctions in the sliding mechanism after installing a front seat.
- When performing the procedure with a front seat removed from the vehicle, perform the procedure on a clean rag so as not to damage or soil the seat.

Removal

1. Turn the ignition switch to LOCK position.

2. Disconnect the negative battery cable and wait 1 min or more.

3. Remove the front seat. Front Seat Removal/Installation

4. Remove the front seat side cover. Front Seat Side Cover Removal/Installation

5. Cut the band A securing the harness.






6. Remove the clip B.

7. Slide hook C in the order of (1), (2), (3) shown in the figure to detach it from hook D.






8. Cut the band E securing the side air bag wiring harness.






9. Cut the band F securing the side air bag wiring harness.






10. Remove the bolts G, then remove the front seat back component.






Installation

1. Install the bolts G, then install the front seat back component.






2. Install the band F, while tighten the side air bag wiring harness.






NOTE:
- Install the band with the end pointed to the Bottom.

3. Install the band E, while tighten the side air bag wiring harness.






NOTE:
- Install the band with the end pointed to the Bottom.

4. Cut off the end of the band at the position shown in the figure.






5. Slide hook C in the order of (4), (5), (6) shown in the figure to install it to hook D.






6. Install the clip B.






7. Install the band A, while tighten the harness.