Side Air Bag Module Removal/Installation

SIDE AIR BAG MODULE REMOVAL/INSTALLATION

WARNING:
- Handling the air bag module improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the service warnings and cautions before handling the air bag module. Air Bag System Service Warnings Air Bag System Service Cautions
- If the side air bag module is installed with debris in the seat back, the foreign material may be scattered when the side air bag module operates (deploys), causing injury. Verify that there is no foreign material in the seat back before installing the side air bag module.

1. Turn the ignition switch to the LOCK position.

2. Disconnect the negative battery cable and wait for 1 min or more.

3. Remove the front seat back trim. Front Seat Back Trim Removal/Installation

4. Remove the front seat cushion. Front Seat Cushion Trim Removal/Installation

5. Remove the clip as shown in the figure.






6. Remove the nuts.






7. Remove the side air bag module.

8. Install in the reverse order of removal.

9. Turn the ignition switch to the ON position.

10. Verify that the air bag system warning light illuminates for approx. 6 s and goes out.

- If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and perform inspection of the system.

Band Installation Note

1. Install the band with the end pointed to the front.






2. Cut off the end of the band at the position shown in the figure.