Fuel Delivery and Air Induction: Service and Repair

INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [L3]

WARNING:
- A hot engine and intake air system can cause severe burns. Turn off the engine and wait until they are cool before removing the intake air system.
- Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedure", while referring to the "BEFORE SERVICE PRECAUTION". Before Service Precaution

1. Remove the battery cover and battery duct. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the plug hole plate. Service and Repair

4. Remove in the order indicated in the table.

5. Install in the reverse order of removal.

6. Complete the "AFTER SERVICE PRECAUTION". After Service Precaution










Fresh-air Duct Removal Note

1. Remove the front bumper before removing the fresh-air duct. Removal and Replacement

Throttle Body Removal Note

1. Drain the engine coolant. Service and Repair

2. Disconnect the throttle body connector.

3. Disconnect the water hose connecting the throttle body.

4. Remove the throttle body.

Intake Manifold Removal Note

1. Remove the battery, battery tray and PCM component. Removal and Replacement

2. Remove the under cover.

3. Disconnect the vacuum hose connecting the intake manifold. Service and Repair

Air Cleaner Case Installation Note

NOTE:
- Before installing the air cleaner case, verify that the rubber mounts on the battery support bracket have not fallen off.
- When inserting the air cleaner case into the rubber mounts, applying soapy water aids the operation.

1. Verify that two rubber mounts are installed on the battery support bracket.

2. Install the air cleaner case into the rubber mounts.

Strap Installation Note

1. Using the strap, secure the shroud panel and the air cleaner case as shown in the figure.






Air Hose Installation Note

1. Align the alignment marks on the throttle body and the air hose.