Air Bag Control Module: Service and Repair

SAS CONTROL MODULE REMOVAL/INSTALLATION

WARNING:
- Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module. Air Bag System Service Warnings Air Bag System Service Cautions

CAUTION:
- Handling the SAS control module improperly can accidentally deploy the air bag modules and pre-tensioner seat belt, which may seriously injure you. If configuration is not completed before removing the SAS control module, DTC B2477 will be displayed.

1. Perform SAS control module configuration when replacing it. Testing and Inspection

2. Turn the ignition switch to the LOCK position.

3. Remove the battery cover. Removal and Replacement

4. Disconnect the negative battery cable and wait for 1 min or more.

5. Remove the side wall. Side Wall Removal/Installation

6. Remove the center console (Vehicles with rear vent) Center Console Removal/Installation

7. Remove the front console. Front Console Removal/Installation

8. Remove in the order indicated in the table.










9. Install in the reverse order of removal.

10. Turn the ignition switch to the ON position.

- If the SAS control module is replaced, turn the ignition switch to the ON position for 20 s or more after completing the configuration. Testing and Inspection

11. Verify that the air bag system warning light illuminates for approx. 6 s and then goes out.

- If the air bag system warning light does not operate normally, refer to the on-board diagnostic system (air bag system) and inspect the system. Flowchart