Overhaul

FRONT SHOCK ABSORBER AND COIL SPRING DISASSEMBLY/ASSEMBLY

WARNING:
- Before removing the piston rod nut, secure the shock absorber and coil spring in the SSTs. Otherwise, the coil spring could fly off under tremendous pressure and cause serious injury or death, or damage to vehicle parts.

1. Remove the front shock absorber and coil spring. Front Suspension

2. Disassemble in the order indicated in the table.

3. Assemble in the reverse order of removal.










Piston Rod Nut Removal Note

WARNING:
- Before removing the piston rod nut, secure the shock absorber and coil spring in the SSTs. Otherwise, the coil spring could fly off under tremendous pressure and cause serious injury or death, or damage to vehicle parts.

1. Install the shock absorber and coil spring to the SST according to the following procedures.
NOTE:
- Install the SST using a piece of clean rag to prevent the coil spring from being scratched.

a. Set the SST attachment (tabs) to the positions shown in the figure.






b. Install the front shock absorber and coil spring to the SST so that the coil spring is set the position shown in the figure.






2. Compress the coil spring using the SSTs and remove the piston rod nut.






Coil Spring Installation Note

1. Compress the coil spring using the SSTs.






2. Install the shock absorber so that the lower end of the coil spring is seated on the step of the lower spring seat.

Dust Boot Installation Note

1. Install the dust boot by hooking the bottom edge over the shock absorber lip.






Bearing Installation Note

1. Install the bearing by hooking the upper end of the dust boot to the bearing lip.






2. Align the projection A on the lower part of the shock absorber with the bearing projection B.