Input/Turbine Speed Sensor Removal/Installation - FS5A-EL

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL]

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Remove the battery duct. Removal and Replacement

4. Remove the battery, battery box and battery tray. Removal and Replacement

5. Remove the air cleaner component. Service and Repair

6. Disconnect the input/turbine speed sensor connector.






7. Remove the input/turbine speed sensor.

8. Apply ATF to a new O-ring and install it on input/turbine speed sensor.

9. Install the input/turbine speed sensor using a new bolt.

CAUTION:
- Always use a new bolt. If the removed bolt is reused, it may cause oil leakage.
- A sealant coating is applied to the input/turbine speed sensor installation bolt to prevent oil leakage from the installation bolt hole which passes through the component.

Tightening torque
- 8-11 Nm {82-112 kgf-cm, 71-97 in-lbf}

10. Connect the input/turbine speed sensor connector.

11. Install the air cleaner component. Service and Repair

12. Install the battery, battery box and battery tray. Removal and Replacement

13. Install the battery duct. Removal and Replacement

14. Connect the negative battery cable.

15. Install the battery cover. Removal and Replacement