Steering Lock Unit ID Code Registration

STEERING LOCK UNIT ID CODE REGISTRATION

CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed.

- M-MDS
- Personal computer
- Device that can send/receive radio waves

NOTE:
- The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit. Service and Repair
- For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.

1. Bring the programmed card key into the vehicle.

2. Fully lower the driver-side door glass.

3. Connect the M-MDS to the DLC-2.






4. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.

CAUTION:
- Protect the cable and body contact area with a clean rag, otherwise they could be damaged.

5. After vehicle identification, select the following from the M-MDS initial screen.

- Using an IDS (laptop PC)

- Select "Body".
- Select "Security".
- Select "PATS Functions".

- Using a PDS (pocket PC):

- Select "Programming".
- Select "PATS Functions".

6. Then, select an item from the screen menu.

- Steering Lock Unit Programming

7. Perform the security access according to the directions on the M-MDS screen.