Planetary Gear Component Inspection

PLANETARY GEAR COMPONENT INSPECTION





1. Using a dial gauge, measure the inner diameter of the front planetary ring gear flange bushings.

Front planetary ring gear bushing inner diameter:
46.038-46.063 mm (1.81252-1.81350 in)

Caution:
^ Measure at different places and take an average. If it exceeds the specification, replace the front planetary ring gear flange with a new one.
^ When the front planetary ring gear flange is replaced, inspect the contact surface opposed to the middle planetary gear component.
^ If the surface of it is scratched or has changed color, replace the middle planetary gear component with a new one.





2. Using a dial gauge, measure the inner diameter of the front planetary gear component bushings.

Front planetary gear component bushing inner diameter:
48.755-48.780 mm (1.91949-1.92047 in)

Caution:
^ Measure at different places and take an average. If it exceeds the specification, replace the front planetary gear component with a new one.
^ When the front planetary gear component is replaced, inspect the contact surface opposed to the clutch hub.
^ If the surface of it is scratched or has changed color, replace the clutch hub with a new one.





3. Using a dial gauge, measure the inner diameter of the rear planetary gear component bushings.

Rear planetary gear component bushing inner diameter:
18.000-18.025 mm (0.7087-0.7096 in)

Caution:
^ Measure at different places and take an average. If it exceeds the specification, replace the rear planetary gear component with a new one.
^ When the rear planetary gear component is replaced, inspect the contact surface opposed to the intermediate shaft.
^ If the surface of it is scratched or has changed color, replace the intermediate shaft with a new one.