Front Suspension - Stabilizer Removal/Installation

FRONT STABILIZER REMOVAL/INSTALLATION [L3 WITH TC]

1. Remove the joint cover. Steering Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System Steering Wheel And Column Removal/Installation - With Advanced Keyless Entry And Push Button Start System

2. Disconnect the steering shaft from the steering gear and linkage. Steering Wheel And Column Removal/Installation - Without Advanced Keyless Entry And Push Button Start System Steering Wheel And Column Removal/Installation - With Advanced Keyless Entry And Push Button Start System

3. Remove the front auto leveling sensor. (Vehicles with AFS) Service and Repair

4. Remove the front crossmember component. Service and Repair

5. Remove in the order indicated in the table.

6. Install in the reverse order of removal.

7. Inspect the wheel alignment and adjust it if necessary. Front Wheel Alignment










Front Stabilizer, Stabilizer Bushing and Stabilizer Bracket Installation Note

CAUTION:
- Verify that the stabilizer bushings are not caught between the stabilizer bracket and the front crossmember, and install the stabilizer bracket using the following procedure.

1. Temporarily tighten bolts A and B shown in the figure.

2. Tighten bolt A.

3. Tighten bolt B.

4. Tighten bolt A.