Neutral Switch Removal/Installation [A26M-R]

NEUTRAL SWITCH REMOVAL/INSTALLATION [A26M-R]

1. Disconnect the negative battery cable.

2. Disconnect the neutral switch connector.

3. Remove the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation

4. Remove the neutral switch.






5. Install the neutral switch to the transaxle case.

Tightening torque
- 29-52 Nm {2.9-5.3 kgf-m, 21-38 ft-lbf}

6. Install the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation

7. Connect the negative battery cable.