3RD Counter Gear, 3RD/4TH Clutch Hub Component and 3RD/4TH Shift Fork Assembly Note
3rd Counter Gear, 3rd/4th Clutch Hub Component and 3rd/4th Shift Fork Assembly Note1. Assemble the 3rd drive gear and 3rd/4th clutch hub component.
Caution:
^ Be sure to assemble the clutch hub components and synchronizer ring components while aligning the synchronizer ring grooves with the synchronizer keys.
^ The standard synchronizer key dimensions are as follows:
^ Be sure to align the synchronizer ring projections with the inner cone notches.
^ Be sure to assemble the gears and the synchronizer ring components while aligning the double cone projections with the gear holes as shown in the figure.
^ Align the friction damper projections with the clutch hub grooves.
^ Align the clutch hub sleeve alignment mark with the clutch hub synchronizer key installation position and assemble.
2. Assemble the 3rd counter gear component, 3rd/4th clutch hub component, and 3rd/4th shift fork component as a single unit.
3. Install the 3rd/4th shift rod retaining bolt.
Tightening torque:
21.6 - 30.4 N-m (2.21 - 3.09 kgf-m, 16.0 - 22.4 ft-lbf)