Steering Angle Signal Initialization Procedure

STEERING ANGLE SIGNAL INITIALIZATION PROCEDURE

WARNING:
- If the initialization procedure of the steering angle signal is not completed, the DSC will not operate properly and may cause an accident. Therefore, always perform initialization of the DSC HU/CM steering angle signal to ensure proper DSC operation when any of the following items are performed.

- Steering angle sensor replacement
- DSC HU/CM replacement

1. Inspect the wheel alignment and inflation pressure.

- If there is any malfunction, adjust the applicable part.

2. Park the vehicle on level ground.

3. Turn the ignition switch to the LOCK position.

4. Connect the M-MDS to the DLC-2.






5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

- Select "Chassis".
- Select "ABS/DSC".
- Select "Sensor Initialization".

- When using the PDS (Pocket PC)

- Select "All Tests and Calibrations".
- Select "Sensor Initialization".

6. Perform the initialization procedure according to the directions on the screen.

7. Drive the vehicle forward.

8. After 5 min of driving, verify that the DSC system is normal.