Gear Sensor/Switch: Testing and Inspection

NEUTRAL SWITCH INSPECTION [LF]

NOTE:
- Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. Description and Operation

Continuity Inspection

1. Remove the neutral switch. M15M-D
P66M-D

2. Verify that the continuity between neutral switch terminals 1A and 2A is as indicated in the table.

- If not as indicated in the table, replace the neutral switch. M15M-D P66M-D
- If the monitor item condition/specification (reference) is not within the specification, even though there is no malfunction, perform the "Circuit Open/Short Inspection".





Circuit Open/Short Inspection

1. Disconnect the PCM connector. Service and Repair

2. Inspect the following wiring harness for open or short circuit (continuity Inspection).






Open circuit

- If there is no continuity, there is an open circuit. Repair or replace the wiring harness.

- Neutral switch terminal 2A and PCM terminal 1X
- Neutral switch terminal 1A and body ground

Short circuit

- If there is continuity, there is a short circuit. Repair or replace the wiring harness.

- Neutral switch terminal 2A and body ground