Flywheel: Testing and Inspection

FLYWHEEL INSPECTION

1. Refer to CLUTCH UNIT REMOVAL/INSTALLATION to remove the flywheel. Removal and Replacement

2. Inspect the surface that contacts the clutch disc for scratches, nicks, and discoloration.
NOTE:
1 Correct slight scratches and discoloration using sandpaper.





2 Inspect the runout of the surface that contacts the clutch disc with the flywheel installed to the crankshaft.

3. Inspect the ring gear teeth for damage and wear.

4. Install the flywheel. Removal and Replacement

5. Measure the runout of the surface that contacts the clutch disc using a dial gauge.






- If it exceeds the maximum specification, replace the flywheel.

Flywheel maximum runout
- 0.1 mm {0.004 in}