Courtesy Lamp: Service and Repair

INTERIOR LIGHT REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the rain sensor cover. (Vehicles with auto light/wiper system) (See Service and Repair)

3. Remove the following parts:
a. Sunroof seaming welt (vehicles with sunroof)

b. A-pillar trim A-Pillar Trim Removal/Installation

c. Front scuff plate Front Scuff Plate Removal/Installation

d. Rear scuff plate Rear Scuff Plate Removal/Installation

e. B-pillar lower trim B-Pillar Lower Trim Removal/Installation

f. Upper anchor of the front seat belt Standard Deployment Control System Two-Step Deployment Control System

g. B-pillar upper trim B-Pillar Upper Trim Removal/Installation

h. Rear seat cushion Rear Seat Cushion Removal/Installation

i. Tire house trim Tire House Trim Removal/Installation

j. Trunk side upper trim (5HB)

k. C-pillar trim C-Pillar Trim Removal/Installation

l. Map light Map Light Removal/Installation

m. Sunvisor Service and Repair

n. Assist handle Service and Repair

o. Headliner Service and Repair

4. Pull in the direction of the arrows and detach the tabs.






5. Disconnect the connector.

6. Remove the interior light.

7. Install in the reverse order of removal.

NOTE:
- After installing the wiring harness, reinforce the urethane that was cut when removing the valve housing with vinyl tape.