Manual Transmission/Transaxle: Testing and Inspection

TRANSAXLE OIL INSPECTION [A26M-R]

1. Park the vehicle on level ground.

2. Remove the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation

3. Remove the oil level plug and gasket.






4. Verify that the oil is near the brim of the plug port.

- If the oil level is low, add the specified amount and type of oil through the filler plug hole.

Manual transaxle oil grade
- API service GL‐4

Manual transaxle oil viscosity
- SAE 75W-80

5. Tighten the oil level plug with a new gasket.

Tightening torque
- 28-51 Nm {2.9-5.2 kgf-m, 21-37 ft-lbf}

6. Install the aerodynamic under cover No.2. Aerodynamic Under Cover No.2 Removal/Installation