Steering Lock Unit ID Code Registration

STEERING LOCK UNIT ID CODE REGISTRATION [WITH ADVANCED KEYLESS ENTRY AND START SYSTEM]

CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed:

- M-MDS
- Personal computer
- Devices that can send/receive radio waves

NOTE:
- The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit. (See Service and Repair)
- For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.

1. Bring the programmed advanced key into the vehicle.

2. Fully lower the driver-side door glass.

3. Connect the M-MDS to the DLC-2.






4. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.

CAUTION:
- Cover the vehicle body with a clean rag so as not to damage the vehicle body with the cable.

5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

- When using the IDS (laptop PC)

- Select "Body"
- Select "Security"
- Select "PATS Functions"

- When using the PDS (Pocket PC)

- Select "All Tests and Calibrations"
- Select "PATS Functions"

6. Then, select items from the screen menu in the following order.

- Select "Steering Lock Unit Programming"

7. Perform the security access according to the directions on the M-MDS screen.