Dynamic Stability Control

FRONT ABS WHEEL-SPEED SENSOR INSPECTION

Installation Visual Inspection

1. Inspect the following items:

- If there is any malfunction, replace the applicable part.

a. Excessive play of the front ABS wheel-speed sensor

b. Deformation of the front ABS wheel-speed sensor

Clearance inspection

1. Remove the front ABS wheel-speed sensor.

2. Measure the distance between the front ABS wheel-speed sensor installation surface and the front ABS sensor rotor. This is dimension A.






3. Calculate the clearance between the front ABS wheel-speed sensor and the front ABS sensor rotor using the following formula:

- Clearance (mm {in}) = A-15 mm {0.59 in}

4. Verify that the clearance between the front ABS sensor rotor and the front ABS wheel-speed sensor is as indicated below.

- If there is any malfunction, verify the installation condition and replace if necessary.

Clearance
- 0.3-1.0 mm {0.02-0.03 in}

Sensor Output Value Inspection

CAUTION:
- Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor.

1. Turn the ignition switch off.

2. Connect the M-MDS to the DLC-2.






3. Select the following PIDs using the M-MDS:

- LF_WSPD
(LF wheel-speed sensor)
- RF_WSPD
(RF wheel-speed sensor)

4. Start the engine and drive the vehicle.

5. Verify that the display of the M-MDS shows the same value as the speedometer.

- If there is any malfunction, replace the front ABS wheel-speed sensor.