Programming and Relearning

INSTRUMENT CLUSTER CONFIGURATION

NOTE:
- If the instrument cluster is replaced with a new one, the odometer data (total traveled distance) from the previous instrument cluster cannot be copied.

1. Connect the M-MDS to the DLC-2.






2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.

- When using the IDS (laptop PC)

- Select the "Module Programming".

- When using the PDS (Pocket PC)

- Select the "Programming".
- Select the "Module Programming".

3. Then, select items from the screen menu in the following order.
1 Select "Programmable Module Installation".
2 Select "IC".

4. Perform the configuration according to the directions on the screen.

5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.

- If a DTC (s) is detected, perform the applicable DTC inspection. Instrument Cluster - DTC Table