Programming and Relearning

PCM CONFIGURATION [13B-MSP]

CAUTION:
- If the wheel and tire sizes are changed, the set value for the tire rotation diameter will be different, causing a discrepancy whereby the speedometer needle exceeds the allowable range. If the wheel and tire sizes are changed, perform a PCM configuration to change the tire size setting.

Newly Replacing PCM
- Connect the M-MDS to the DLC-2.





- After the vehicle is identified, select the following items from the initial screen of the M-MDS.

- When using the IDS (laptop PC)

1 Select the "Module Programming".

- When using the PDS (Pocket PC)

1 Select the "Programming".
2 Select the "Module Programming".

- Then, select items from the screen menu in the following order.

- Select "Programmable Module installation".
- Select "PCM".

- Perform the configuration according to the directions on the screen.
- Retrieve DTCs by the M-MDS, then verify that there is no DTC present.

- If a DTC(s) is detected, perform the applicable DTC inspection. Engine - DTC Table

Wheel And Tire Size Change
- Connect the M-MDS to the DLC-2.





- After the vehicle is identified, select the following items from the initial screen of the M-MDS.

- When using the IDS (laptop PC)

- Select the "Module Programming".

- When using the PDS (Pocket PC)

- Select the "Programming".
- Select the "Module Programming".

- Then, select items from the screen menu in the following order.

- Select "Programmable Parameters".
- Select "Tire Size / Axle Ratio".

- Select an item name, and then select option.

Items
- Tire Size ("225/40R19"/"225/45R18"/"225/50R17")