Fuel Delivery and Air Induction: Service and Repair

INTAKE-AIR SYSTEM REMOVAL/INSTALLATION [13B-MSP]

WARNING:
- A hot engine and intake-air system can cause severe burns. Turn off the engine and wait until they are cool before removing the intake-air system.
- Fuel line spills and leakage from the pressurized fuel system are dangerous. Fuel can ignite and cause serious injury or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete the "Fuel Line Safety Procedure", while referring to the "BEFORE SERVICE PRECAUTION".

1. Complete the "BEFORE SERVICE PRECAUTION". Before Service Precaution

2. Disconnect the negative battery cable. Removal and Replacement

3. Remove the engine cover. Service and Repair

4. Drain the engine coolant. Service and Repair

5. Remove in the order indicated in the table.

6. Install in the reverse order of removal.

7. Complete the "AFTER SERVICE PRECAUTION". After Service Precaution









Extension Manifold (Upper) Removal Note

1. Remove the front suspension tower bar. Front Suspension Tower Bar Removal/Installation - MT

2. Remove the bracket as shown in the figure.






3. Remove the extension manifold (upper).

Fresh-air Duct Removal Note

1. Remove the front bumper. Removal and Replacement

2. Remove the fresh-air duct.

Fresh-air Duct Installation Note

1. Install the fasteners.

2. Tighten the bolt to the specified torque.






Tightening torque
- 7.8-10.8 Nm {80-110 kgf-cm, 70-95 in-lbf}

Air Cleaner Insulator Installation Note

1. Temporarily tighten nuts.

2. Temporarily tighten bolts.

3. Tighten the nuts to the specified torque.

4. Tighten the bolts to the specified torque.






Tightening torque
- 7.8-10.8 Nm {80-110 kgf-cm, 70-95 in-lbf}

Air Hose Installation Note

1. Align the alignment marks with the air hose notches.