Request Switch Removal/Installation - With Advanced Keyless Entry And Start System

REQUEST SWITCH REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND START SYSTEM]

Driver-side/passenger-side

1. Disconnect the negative battery cable.

2. Remove the front door trim. Front Door Trim Removal/Installation

3. Remove the front outer handle. Service and Repair

4. Remove the screws A, then remove the handle seat and plate.

5. Remove screw B, then remove the request switch.






Trunk Lid

1. Disconnect the negative battery cable.

2. Remove the rear bumper. Removal and Replacement

3. Detach the request switch from the rear bumper.

4. Install in the reverse order of removal.