Clutch Pedal Assembly: Service and Repair

CLUTCH PEDAL REMOVAL/INSTALLATION

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.

3. Inspect and adjust the clutch pedal. Adjustments









Clutch Pedal Component Installation Note

CAUTION:
- Always verify the tightening order for the clutch pedal installation nuts before performing the procedure. If there is a malfunction in the tightening order, it could result in bracket deformation.

1. Install the clutch pedal component, and then temporarily tighten the nut A.






2. Install the clip.

3. Tighten the nuts B(2).






Tightening torque
- 18.6-25.5 Nm {1.90-2.60 kgf-m, 13.7-18.8 ft-lbf}

4. Tighten the nut A.

Tightening torque
- 18.6-25.5 Nm {1.90-2.60 kgf-m, 13.7-18.8 ft-lbf}

Starter Interlock Switch Installation Note

CAUTION:
- If the rod is pushed in, it may not operate properly. Be careful not to push the rod in when installing the starter interlock switch.

1. Insert a new starter interlock switch into the pedal bracket hole in direction A.

2. While pushing the starter interlock switch in direction A, slide it in direction B until it locks securely.

3. Move the clutch in a fully open stroke in direction C and securely fit the terminal of the starter interlock switch.