Front Bumper Removal/Installation

FRONT BUMPER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable. (Vehicles with front fog lights)

2. Remove screw A and screws B, and set the mudguard out of the way in the direction of the arrow shown in the figure.






3. Remove screws C.






4. Remove the fastener D.






5. Remove the bolts from position (1) indicated in the figure, pull the front bumper in the direction of arrow (2) shown in the figure to disengage the both ends from the front bumper slider, then remove the front bumper in the direction of arrow (3).






CAUTION:
- The front bumper and front bumper slider are engaged firmly. If they are disengaged forcibly the bumper could fall and be damaged. Perform the servicing carefully when disengaging the front bumper from the front bumper slider.
- When disengaging the front bumper from the front bumper slider, the front bumper could fall and be damaged. Support the front bumper so that it does not fall.

6. Disconnect the front fog light connector. (Vehicles with front fog lights)

7. Install in the reverse order of removal.

8. Adjust the front fog light aiming for vehicles with front fog lights. (See Adjustments)

Front Bumper Installation Note

1. Spread the front bumper ends apart.

2. Assemble the front bumper to the body.

3. Press the front bumper connecting area in the direction of the arrow shown in the figure to engage with the front bumper slider.