Front Door Latch: Service and Repair

FRONT DOOR LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION

1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 110 mm {4.33 in}.






2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Inner garnish Inner Garnish Removal/Installation

b. Front door trim Front Door Trim Removal/Installation

c. Front inner handle Door Lock-Link Switch Inspection

d. Front door speaker Front Door Speaker Removal/Installation

e. Front door glass Service and Repair

f. Front door module panel Front Door Module Panel Removal/Installation

g. Rod protector Service and Repair

4. Lift the clip in the direction of the arrow (1), and pull out the key rod in the direction of the arrow (2).






5. Remove the screw






6. Detach the clips.

7. Press down the rod holder of the front door latch and lock actuator in the direction of the arrow.






8. Maintaining the condition in procedure 7, remove the front door latch and lock actuator.






9. Install in the reverse order of removal.