Cruise Control Switch: Testing and Inspection
CRUISE CONTROL SWITCH INSPECTION [MZR 1.5]
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more.
3. Remove the driver-side air bag module. Driver-Side Air Bag Module Removal/Installation
4. Disconnect the clock spring connector (part wiring harness-side).
5. Inspect for resistance and continuity between clock spring terminals B and D (part wiring harness-side) using a tester.
- If not as specified, replace the audio control switch. Service and Repair
6. Apply battery positive voltage to clock spring terminal G (part wiring harness-side) and terminal E (part wiring harness-side) to ground.
7. Verify that the LED illuminates.
- If the LED does not illuminate, replace the audio control switch. Service and Repair