Cylinder Block Assembly (II)

CYLINDER BLOCK ASSEMBLY (II)

1. Assemble in the order indicated in the table.






Inner Rotor, Outer Rotor Assembly Note




1. Assemble the inner rotor and the outer rotor with the punch marks aligned.

Oil Pan Assembly Note

Caution: Install the oil pan before the applied silicone sealant starts to harden.




1. Apply silicone sealant as shown in the figure.

Diameter: 2.0-6.0 mm {0.08-0.23 in}




2. Tighten the oil pan installation bolts in the order shown in the figure.

Tightening torque: 8-10 N.m {82-101 kgf.cm, 71-88 in.lbf}

Oil Filter Assembly Note




1. Install the oil filter according to the instruction on the package or side of the oil filter.

Note: Tightening torque: 12-15 N.m {123-152 kgf.cm, 107-132 in.lbf}

Angle tightening
When the O-ring contacts the oil filter installation surface, turn the filter another one rotation.

Rear Oil Seal Assembly Note
1. Apply clean engine oil to a new rear oil seal.
2. Insert the rear oil seal to the cylinder block by hand.








3. Install the rear oil seal using the SST.

Drive Plate (ATX), Flywheel (MTX) Assembly Note




1. Lock the drive plate (ATX) or flywheel (MTX) against rotation using the SST.
2. Tighten the flywheel installation bolts in two to three passes in the order shown in the figure.

Oil Pump Assembly Note




1. Install the gasket to the oil pump.
2. Install the oil pump and gasket as a single unit.

Knock Sensor Assembly Note




1. Install the knock sensor using the SST.