Cylinder Head Assembly (II)

CYLINDER HEAD ASSEMBLY (II)

1. Assemble in the order indicated in the table.






Cylinder Head Assembly Note




1. Tighten the cylinder head installation bolts in three steps in the order shown in the figure.

1 Tightening torque 18-22 N.m {1.9-2.2 kgf.m, 14-16 ft.lbf}
2 Tightening angle 85° -95°
3 Tightening angle 85° -95°

Camshaft Assembly Note

Note: Install the camshaft with the No.1 camshaft positioned at TDC of the compression stroke.




1. Install the camshaft cap to the position shown in the figure, and temporarily tighten the No.2 and No.7 camshaft installation bolts.
2. Tighten the camshaft cap installation bolts in two to three passes uniformly in the order shown in the figure.

Tightening torque: 12-14 N.m {123-142 kgf.cm, 107-123 in.lbf}

Camshaft Sprocket, Variable Valve Timing Actuator Assembly Note




1. Fix the camshaft using a suitable wrench on the cast hexagon as shown in the figure.
2. Tighten the camshaft sprockets and variable valve timing actuator installation bolts.

Tightening torque: 50-60 N.m {5.1-6.1 kgf.m, 37-44 ft.lbf}