Rear Combination Light Removal/Installation

REAR COMBINATION LIGHT REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.

2. Remove the screws.






3. To prevent scratches or damage, affix protective tape to the position shown in the figure.
NOTE:
- When the rear combination light is removed from the body, perform the procedure after affixing protective tape to the body. Otherwise, the body could interfere with the rear combination light and cause scratching or damage to the body.





4. Pull the rear combination light in the direction of the arrow shown in the figure, remove the hook from the clip, and remove the pin from the grommet.






5. Rotate the socket in the direction of the arrow shown in the figure and remove it.






6. Remove the wiring harness from the hook.






7. Remove the rear combination light.

8. Install in the reverse order of removal.