Component Tests and General Diagnostics

EPS CONTROL MODULE INSPECTION

1. Remove the side wall. Side Wall Removal/Installation

2. Remove the front console component. Front Console Component Removal/Installation

3. Remove the front scuff plate (LH) and front side trim (LH). Front Scuff Plate Removal/Installation Front Side Trim Removal/Installation

4. Disconnect the hood release lever from the lower panel. Service and Repair

5. Remove the lower panel. Lower Panel Removal/Installation

6. Remove the heat duct (LH). Heater Duct Component Removal/Installation

7. Attach the tester lead to the underside of the EPS CM connector and inspect the voltage according to the terminal voltage table (reference).

Terminal Voltage Table (Reference)