Removal and Replacement

STEERING GEAR AND LINKAGE REMOVAL/INSTALLATION

1. Remove the steering shaft cover. Service and Repair

2. Disconnect the intermediate shaft from the steering gear and linkage. Service and Repair

CAUTION:
- The EPS will not operate properly if the installation is performed with the steering shaft rotated 360 degrees by mistake. After detaching the intermediate shaft, secure the steering shaft to prevent it from rotating until the intermediate shaft is installed to the steering gear and linkage.
- Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.

3. Remove in the order indicated in the table.

4. Install in the reverse order of removal.

5. After installation, inspect the front wheel alignment. Front Wheel Alignment









Steering Gear and Linkage Installation Note

1. Temporarily install the steering gear to the front crossmember using bolts.

2. Tighten the bolts to the specified torque.