Rear Door Window Motor: Service and Repair

POWER WINDOW MOTOR REMOVAL/INSTALLATION

Rear Power Window Motor

1. Fully lower the rear door glass.

2. Disconnect the negative battery cable.

3. Remove the sail inner garnish. Sail Inner Garnish Removal/Installation

4. Remove the rear door trim. Rear Door Trim Removal/Installation

CAUTION:
- If the bolts are removed without supporting the rear door glass, the rear door glass may fall off and be damaged. Remove the bolts while inserting your hand into the rear door speaker installation hole to support the rear door glass.





5. Disconnect the rear power window motor connector, remove the bolt, then remove the power window motor from the power window regulator drum.






6. Install in the reverse order of removal.
NOTE:
- When installing the rear power window motor to the rear power window regulator drum, the drum housing hooks may detach from the door module panel. If this happens, remove the door speaker, insert your hand in the speaker installation hole, connect the drum housing hooks, and while supporting the drum housing, install the rear power window motor to the drum.