Power Window Main Switch Inspection

POWER WINDOW MAIN SWITCH INSPECTION

1. Switch the ignition to ON.

2. Verify that the door glass (driver's side) can be operated forapprox. 43 s after the ignition switched to off.

- If the door glass (driver's side) cannot be operated forapprox. 43 s after the after the ignition switched to off, of if the door glass (driver's side) can still be operated afterapprox. 43 s, replace the power window main switch.

3. Disconnect the negative battery cable.

4. Remove the inner garnish. (See Inner Garnish Removal/Installation.)

5. Remove the front door trim. (See Front Door Trim Removal/Installation.)

6. Remove the switch panel. (See Overhaul.)

7. Connect the power window main switch connector.

8. Connect the negative battery cable.

9. Measure the voltage at each terminal.

- If the voltage is not as specified in the terminal voltage table, inspect the parts under Inspection item(s) and related wiring harnesses.

10. If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window main switch.






Terminal Voltage Table (Reference)