Radiator Support: Service and Repair

SHROUD PANEL REMOVAL/INSTALLATION

CAUTION:
- Because the shroud panel is installed to the bumper reinforcement, support the shroud panel using a jack before removing the bumper reinforcement so as not to apply excessive force to the shroud panel.
- Since the servicing is performed with the hood open, secure the hood using a piece of wood to prevent it from falling.

1. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

2. Remove the following parts:
a. Front bumper Front Bumper Removal/Installation

b. Front combination lights Front Combination Light Removal/Installation Adjustments

c. Seal plate Seal Plate Removal/Installation

d. Front bumper reinforcement Service and Repair

3. Disconnect the hood latch cable. Service and Repair

4. Remove the bolts.






5. Push the hooks in the direction of arrow (1), and remove the upper mount bracket in the direction of the arrow (2).






6. Pull the shroud panel in the direction of arrow (3) in the figure, and remove it in the direction of arrow (4).






CAUTION:
- Support the lower surface of the radiator with a floor jack to prevent the radiator from falling off after the shroud panel is removed.

7. Install in the reverse order of removal.