Door Lock-Link Switch Inspection

DOOR LOCK-LINK SWITCH INSPECTION

Font Door Lock-link Inspection

1. To access the glass installation bolt, position the front door glass so that the distance from the top of the front door glass to the upper part of the front beltline molding is approx. 80 mm {3.1 in}.






2. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

3. Remove the following parts:
a. Inner garnish Inner Garnish Removal/Installation

b. Front door trim Front Door Trim Removal/Installation

c. Front door speaker Front Door Speaker Removal/Installation

d. Front door glass Service and Repair

e. Front door module panel Front Door Module Panel Removal/Installation

f. Front door latch and lock actuator Service and Repair

4. If the door lock condition is to be inspected, pull the door lock-link switch cable, or press it in.






5. Verify that the continuity is as indicated in the table.

- If not as indicated in the table, replace the front door latch and lock actuator.





Rear Door Lock-link Inspection

1. Fully open the rear door glass.

2. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

3. Remove the following parts:
a. Rear door trim Rear Door Trim Removal/Installation

b. Rear inner handle Service and Repair

c. Rear door speaker Rear Door Speaker Removal/Installation

d. Rear power window motor Service and Repair

e. Rear door glass Rear Door Glass Removal/Installation

f. Rear door latch and lock actuator Service and Repair

4. If the door lock condition is to be inspected, pull the door lock-link switch cable, or press it in.






5. Verify that the continuity is as indicated in the table.

- If not as indicated in the table, replace the rear door latch and lock actuator.