Fog/Driving Lamp: Service and Repair

FRONT FOG LIGHT REMOVAL/INSTALLATION

Except Mazdaspeed3

1. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement

2. Remove the front bumper. Front Bumper Removal/Installation

3. Pull the wiring harness from the hook in the direction of the arrow shown in the figure and remove it.






4. Disconnect the connector.

5. Pull the wiring harness in the direction of the arrow (2) shown in the figure and remove it while detaching clip in the direction of the arrow (1).






6. Remove the screw A.






7. Pull the front fog light component in the direction of the arrow shown in the figure and remove it while remove the pins.

8. Remove the bolt.






9. Remove the screw B.

10. Pull the front fog light in the direction of the arrow shown in the figure and remove the pin from the front fog light cover.






11. Remove the front fog light.

12. Install in the reverse order of removal.

13. Adjust the front fog light aiming. Adjustments

Mazdaspeed3

1. Disconnect the negative battery cable. Removal and Replacement

2. Remove the fasteners and slightly bend back the mudguard.

3. While pressing the tab in the direction of arrow (1) shown in the figure, pull the connector in the direction of arrow (2) and disconnect it.






4. Remove the screws shown in the figure and remove the front fog light cover from the front bumper.






5. Remove the screw and bolt shown in the figure.






6. Pull the front fog light in the direction of the arrow shown in the figure and remove it from the front fog light cover.






7. Remove the front fog light.

8. Install in the reverse order of removal.

9. Adjust the front fog light aiming. Adjustments