Manual Air Conditioner
BLOWER MOTOR INSTALLATION [MANUAL AIR CONDITIONER]
1. Install the SST (49 B061 015A) to the blower motor.
2. Install the blower motor with the SST (49 B061 015A) installed, to the A/C unit.
CAUTION:
- To prevent damage to the sirocco fan, install the blower motor being careful that the blower motor does not interfere with the A/C unit. Also, another person must hold the blower motor at the installation position.
3. Rotate the SST (49 B061 015A) until to the blower motor tab locked.
4. Connect the blower motor connector as shown in the figure.
5. Connect the blower motor cooling pipe.
6. Rotate the SST (49 B061 015A) in the direction shown by the arrow.
7. Remove the SST (49 B061 015A) from the blower motor.
8. Install the blower case.
CAUTION:
- Install the blower case while pressing the dashboard insulator, otherwise the blower case could be damaged.
9. Install the screws shown in the figure.
10. Install the harness clip to the blower case.
11. Connect the air intake actuator connector.
12. Install the following parts:
a. Accelerator pedal Service and Repair Service and Repair
b. Shower duct (Passenger-side) Removal and Replacement
c. Lower panel Lower Panel Removal/Installation
d. Hood release lever Service and Repair
e. Dashboard under cover Dashboard Under Cover Removal/Installation
f. Glove compartment Service and Repair
g. Shift panel Shift Panel Removal/Installation
h. Selector lever knob (ATX) Automatic Transaxle Shift Mechanism Removal/Installation
i. Shift lever knob (MTX) Manual Transaxle Shift Mechanism Removal/Installation [G35M-R] Manual Transaxle Shift Mechanism Removal/Installation [G66M-R]
j. Upper panel Upper Panel Removal/Installation
k. Front side trim Front Side Trim Removal/Installation
l. Front scuff plate Front Scuff Plate Removal/Installation
13. Connect the negative battery cable. Removal and Replacement Removal and Replacement
Blower Case Installation Note
1. If not replacing the blower case, replace the adhesive polyurethane on the fresh-air inlet of the blower case.
CAUTION:
- To adhere new polyurethane properly, be sure to remove the adhesive agent and adhesive polyurethane completely.
NOTE:
- If the blower case is removed or installed, the adhesive polyurethane can be damaged. Damaged adhesive polyurethane could cause abnormal noise or other malfunctions, therefore replace it.