Manual Air Conditioner

CLIMATE CONTROL UNIT REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER]

1. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement

2. Remove the following parts:
a. Upper panel Upper Panel Removal/Installation

b. Shift lever knob (MTX) Manual Transaxle Shift Mechanism Removal/Installation [G35M-R] Manual Transaxle Shift Mechanism Removal/Installation [G66M-R]

c. Selector lever knob (ATX) Automatic Transaxle Shift Mechanism Removal/Installation

d. Shift panel Shift Panel Removal/Installation

e. Side wall Side Wall Removal/Installation

f. Console Console Removal/Installation

g. Front scuff plate Front Scuff Plate Removal/Installation

h. Front side trim Front Side Trim Removal/Installation

i. Dashboard under cover Dashboard Under Cover Removal/Installation

j. Glove compartment Service and Repair

k. Hood release lever Service and Repair

l. Lower panel Lower Panel Removal/Installation

m. Center panel Center Panel Removal/Installation

n. Audio unit Audio Unit Removal/Installation

o. Shower duct (driver-side) Removal and Replacement

3. Remove in the order indicated in the table.










4. Install in the reverse order of removal.

Climate Control Unit Removal Note

1. Disconnect each wire to links and remove it to the wire clamps.






2. Pull out the air mix wire and airflow mode wire from the dashboard.






Climate Control Unit Installation Note

1. Pass each wire through the hole on the dashboard as shown in the figure.






2. Route each wire as shown in the figure.






3. Connect the climate control unit connector.

4. Connect each wire to links and install it to the wire clamps.






5. Verify that the dial is turned fully from one end to the other.