Turn Signal Lamp: Testing and Inspection

SIDE TURN LIGHT INSPECTION

Side turn light illumination inspection

1. Disconnect the negative battery cable. Removal and Replacement Removal and Replacement Removal and Replacement

2. Remove the outer mirror glass. Outer Mirror Glass Removal Outer Mirror Glass Installation

3. Remove the outer mirror garnish. Outer Mirror Garnish Removal/Installation

4. Remove the side turn light. Side Turn Light Removal/Installation

5. Connect the battery voltage as shown in the figure.






- If the side turn light does illuminate, replace it.
- If the side turn light illuminate, inspect the short-code.

Short-code inspection

1. Remove the inner garnish. Inner Garnish Removal/Installation

2. Remove the front door trim. Front Door Trim Removal/Installation

3. Disconnect the power outer mirror connector. Power Outer Mirror Removal/Installation

4. Verify that the continuity between side turn light terminals is as indicated in the table.






5. If not as indicated in the table, replace the power outer mirror.