Transmission Temperature Sensor/Switch: Service and Repair
TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR REMOVAL/INSTALLATION [FS5A-EL]
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool.
1. Remove the primary control valve body.
a. Remove the battery cover. Removal and Replacement
b. Disconnect the negative battery cable.
c. Remove the aerodynamic under cover NO.2. Aerodynamic Under Cover No. 2 Removal/Installation
d. Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents.
e. Remove the air cleaner component. Service and Repair
f. Disconnect the coupler component connector.
g. Drain the ATF. Automatic Transaxle Fluid (ATF) Replacement
h. Remove the oil pan.
i. Remove the primary control valve body. Control Valve Body Removal/Installation
2. Remove the coupler component from transaxle case.
3. Remove the O-ring from the coupler component.
4. Install the primary control valve body.
a. Apply ATF to a new O-ring and install it on the coupler component.
b. Install the coupler component to transaxle case.
c. Connect the coupler component connector.
d. Install the primary control valve body. Control Valve Body Removal/Installation
5. Apply a light coat of silicon sealant (TB1217E) to the contact surfaces of the oil pan and transaxle case.
CAUTION:
- If any sealant remains on the sealing surfaces of the transaxle case and oil pan, transaxle damage may occur. Use a cleaning fluid to remove any old sealant from the transaxle case and oil pan.
6. Install the oil pan before the applied sealant starts to harden.
Tightening torque
- 6-8 Nm {62-81 kgf-cm, 54-70 in-lbf}
7. Add the ATF. Automatic Transaxle Fluid (ATF) Replacement
8. Install the aerodynamic under cover NO.2. Aerodynamic Under Cover No. 2 Removal/Installation
9. Install the air cleaner component. Service and Repair
10. Connect the negative battery cable.
11. Install the battery cover. Removal and Replacement
12. Perform the "Mechanical System Test". Mechanical System Test