Radio, Stereo, and Compact Disc: Application and ID

SUPPLIER IDENTIFICATION PROCEDURE [AUDIO]

NOTE:
- The supplier can vary with the unit. When asking the supplier (service center) for repair or replacement, identify the supplier and fill in the Audio Repair Order Form with the following procedures.

Identification Using the Label or Inscribed Lettering

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Upper panel Upper Panel Removal/Installation

b. Decoration panel Decoration Panel Removal/Installation

c. Shift knob (MTX) Service and Repair

d. Shift panel Shift Panel Removal/Installation

e. Center panel lower Center Panel Lower Removal/Installation

f. Center panel upper Center Panel Upper Removal/Installation

g. Climate control unit Full-Auto Air Conditioner Manual Air Conditioner

h. Audio unit Audio Unit Removal/Installation

3. Verify the supplier by referring to the label attached to each unit.






Verify Using the Diagnostic Assist Function

Without display

1. Switch the ignition to ACC or ON.

2. While pressing the POWER/VOLUME switch, simultaneously press the PRESET switch 5 for 3 s or more.






3. Identify the supplier code by referring to the information display.










NOTE:
- The supplier code can also be identified from the DTC displays screen.






4. To stop the diagnostic assist function, ignition is switched to off.

With display

1. Switch the ignition to ACC or ON.

2. While pressing the POWER/VOLUME switch, simultaneously press the Selection switch 5 for 3 s or more.






3. Identify the manufacture code by referring to the display.










NOTE:
- The manufacture code can also be identified from the DTC displays screen.






4. To stop the diagnostic assist function, ignition is switched to off.