Rear Door Lock Actuator Inspection

REAR DOOR LOCK ACTUATOR INSPECTION

1. Fully open the rear door glass.

2. Disconnect the negative battery cable.

3. Remove the following parts:
a. Rear door trim Rear Door Trim Removal/Installation

b. Rear door speaker Rear Door Speaker Removal/Installation

c. Rear door quarter glass Rear Door Quarter Glass Removal/Installation

d. Rear door glass Rear Door Glass Removal/Installation

e. Rear door module panel Rear Door Module Panel Removal/Installation

f. Rear door latch and lock actuator Service and Repair

4. Apply battery positive voltage and connect the ground to each terminal, and then verify the operation.






- If not as indicated in the table, replace the rear door latch and lock actuator.